Tough Not Toxic

Trade Strip Textured Coatings Remover

 

Minimal VOC content; 0.000004%This product allows the safe removal of textured coatings such as Artex® and Polytex® without causing dust from harmful fibres. In the United Kingdom, some plaster-type textured coatings (mainly sold before the mid-1980's) may contain harmful asbestos fibres. Under no circumstances, sand or chip off, or otherwise disturb, the coating, as this may release asbestos fibres.

 

List of products it will safely remove

  • Bonded textured coatings
  • Non-bonded textured coatings
  • Painted wallpapers
  • Textured paints

 

List of suitable substrates:

  • Bonded textured coatings
  • Non-bonded textured coatings Painted wallpapers
  • Textured paints

 

Product Features

  • Water-based
  • Non-hazardous
  • Non-caustic
  • pH-neutral
  • Solvent-free
  • Non-flammable
  • Non-combustible
  • Minimal evaporation.
  • Clings 100% to vertical surfaces - no drips or runs, hence no waste.
  • Economical to use - independent tests have shown that on average Trade Strip goes up to three times as far as dangerous solvent-based strippers
  • Minimal VOC content; 0.000004%, as certified by an independent laboratory, following a flame ionisation detection test.
  • Does not give off fumes - no need for ventilation and no need to work outside
  • Suitable for use by and near people with respiratory problems, such as asthma sufferers.
  • Non-irritant - does not cause skin burns - safe to use around children and pets
  • Wet working system - keeps working for you while wet. If appropriate, re-wet if the product dries out. When working on plasterboard / sheetrock, careful timing required to ensure the plasterboard/ sheetrock substrate is not softened..

 

 

Matrial safety data sheets on this product available on request: